SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> "finger" adjustable air/mix screw?
/cgi-bin/YaBB.pl?num=1449865643

Message started by stewmills on 12/11/15 at 12:27:22

Title: "finger" adjustable air/mix screw?
Post by stewmills on 12/11/15 at 12:27:22

Dave/Versy/Serow (and gang)

Anyone seen these and/or tried to see if there is a version that will fit the Savage? I'd pay $20 for it all day long. Heck, I'd pay $30.

http://www.cv-performance.com/ez-just-mixture-screw/

Title: Re: "finger" adjustable air/mix screw?
Post by verslagen1 on 12/11/15 at 12:35:44

There's been a number of these, but no one's gotten any to find out if they fit.

I believe there are a few HD models that use the other CV mikuni carb.
You should be able to trace down the part numbers to find out if they are the same.

Title: Re: "finger" adjustable air/mix screw?
Post by stewmills on 12/11/15 at 13:13:59

Well if not, then why can't I take a new $10 air/mix screw and a separate brass knurled thingy and solder the two together and make my own?

As JOG calls it, sounds like it's time to go all science project on this one.

The interwebs says you can solder brass like you can copper...and I know how to do copper.

Title: Re: "finger" adjustable air/mix screw?
Post by DesertRat on 12/11/15 at 14:37:43

I'll take one, provided the part #'s cross over to our carbs

Title: Re: "finger" adjustable air/mix screw?
Post by stewmills on 12/11/15 at 14:48:05

At a glance I can't fine one that appears to fit, and one member of another forum didn't seem to think there was one and referred me to ebay. All I found there was for the standard harley carbs and for some other dirt bikes.

If someone wants to spend the time to prove me wrong, please do, just give us the part number to order in the process ;D

Science project, here we come...

Title: Re: "finger" adjustable air/mix screw?
Post by verslagen1 on 12/11/15 at 15:26:07

Most states with inspection requirements will frown these.

Title: Re: "finger" adjustable air/mix screw?
Post by stewmills on 12/11/15 at 16:36:20

7B687F7E616C6A68633C0D0 wrote:

Most states with inspection requirements will frown these.

most states can kiss my donkey's butt. ;D

Title: Re: "finger" adjustable air/mix screw?
Post by justin_o_guy2 on 12/11/15 at 22:45:29

I'd drill and put a piece of wire between.