SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> breather hose
/cgi-bin/YaBB.pl?num=1444503019

Message started by Tocsik on 10/10/15 at 11:50:18

Title: breather hose
Post by Tocsik on 10/10/15 at 11:50:18

Is a replacement for the breather hose easy to find? Mine is cracked and I'm going to head out to a couple shops but thought I would ask if it's anything special since it's thin-walled. Don't want to waste time running around if it's something I need to order.

UPDATE
a motorcycle shop, 3 auto parts stores and an Ace Hardware later, I find this tubing is not readily available. Everything with the correct ID is too thick so it makes the OD huge. gonna hafta pay shipping and fondling charges online >:( Probably burned that much in gas running around in my truck but I wanted the hose while I already had the seat and tank off.

Title: Re: breather hose
Post by Dave on 10/10/15 at 17:45:33

Yep, I had the same experience. The solution was given to me by WD....silicone hose.

I ordered 10mm Silicone Vacuum hose online.

http://www.boostcontroller.com/TurboLogic-Vacuum-Hose-10MM-p/tls-vh-10.htm

Title: Re: breather hose
Post by Tocsik on 10/10/15 at 18:06:34

Hm. I'll give them a shout. Our breather hose is listed as 11X15X600.
Mine is probably stretched/flared even on the end that doesn't look it and I get an ID of 11mm and an OD of 15mm. Not sure what the 600 is for; my breather hose measures about 42 cm so that's a bit shorter than 600 mm.

Title: Re: breather hose
Post by Tocsik on 10/10/15 at 18:21:31

actually ends up cheaper ordering the OEM hose from Ron Ayers after comparing cost plus shipping.