SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Swapping out Handlebars /cgi-bin/YaBB.pl?num=1442606330 Message started by dudebud on 09/18/15 at 12:58:50 |
Title: Swapping out Handlebars Post by dudebud on 09/18/15 at 12:58:50 Im looking into swapping out my handlebars for either a dragbar, clubman or clip ons and i was wondering if its necessary to have the bars drilled or dimpled? |
Title: Re: Swapping out Handlebars Post by verslagen1 on 09/18/15 at 13:06:05 2F3E2F2E293E2F4B0 wrote:
The controls have cast pin on them. File that off and you don't need either. dimpled are for hardly driven wiring. |
Title: Re: Swapping out Handlebars Post by zipidachimp on 09/18/15 at 14:00:17 I always drill for the cast pin, seems I always do things the hard way. 8-) |
Title: Re: Swapping out Handlebars Post by Yoshi on 09/19/15 at 01:21:59 No need to drill, the controls will still stay on tight after dremeling the pins off |
Title: Re: Swapping out Handlebars Post by dudebud on 09/19/15 at 16:43:53 sweet thanks |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |