SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Triple clamps /cgi-bin/YaBB.pl?num=1440917143 Message started by bobdog on 08/29/15 at 23:45:43

Title: Triple clamps Post by bobdog on 08/29/15 at 23:45:43 Any ideas on drilling a lower triple clamp to work with conventional handlebars ?

Title: Re: Triple clamps Post by FerousBastard on 08/30/15 at 02:52:17 I assume you are working out from Gary's ideas over in his fork improvement post: http://suzukisavage.com/cgi-bin/YaBB.pl?num=1421689358 Some don't trust the strength of the softer aluminum, but I reckon it should be doable. Eliminating the big rubber dampers, you'd only need to drill say a couple of 1/2" wholes, have a couple of lugs welded in and drilled to accept the riser bolts. Or you could just drill holes through the triple through to accept the riser bolts and run the chance..

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.