SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Stranded vacuum line /cgi-bin/YaBB.pl?num=1440461482 Message started by Whoas on 08/24/15 at 17:11:15 |
Title: Stranded vacuum line Post by Whoas on 08/24/15 at 17:11:15 Hey guys, just did a petcock replacement on my 87 savage with the reccommended 660. Put about 100 miles on it with no issues and then realized that I had a spare vacuum line on the right side of the carb almost dead center.(I already capped the correct line located towards the bottom from of the carb) Can't seem to find a diagram or picture directing me on where this line goes, any input would help. I capped the line for now and seems to be running fine but not 100% sure that's the final solution. Thank you ahead for any help. * the cap on the left is the line in question* |
Title: Re: Stranded vacuum line Post by verslagen1 on 08/24/15 at 17:53:31 those top ports are vent lines, don't cap them, should have a hose on it that reaches up to the opening in the frame square tube. |
Title: Re: Stranded vacuum line Post by Whoas on 08/25/15 at 13:46:03 Much appreciated |
Title: Re: Stranded vacuum line Post by Dave on 08/25/15 at 13:49:20 I would have tried to help....but the picture posts sideways on my computer. I wouldn't have known my up from my left or right from down! |
Title: Re: Stranded vacuum line Post by verslagen1 on 08/25/15 at 13:59:36 I kept falling out my chair then I copied, paste into a graphics editor. then turned the monitor on its side. :-? |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |