|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> My new S40 work station/hauler/ramp /cgi-bin/YaBB.pl?num=1436153390 Message started by stewmills on 07/05/15 at 20:29:46 |
|
Title: My new S40 work station/hauler/ramp Post by stewmills on 07/05/15 at 20:29:46 So...when I was getting ready to haul my bike to the Dragon I needed two things: 1) a ramp 2) a device to keep my bike stable in the back of my truck. So, I built this that also serves a third purpose, which is a work station. In this pic, I was removing the rear tire so I could inspect and clean the brake dust from riding the rear brakes at the dragon too much so disregard the stack of lumber holding up the rear wheel (the brakes were cleaner than I thought...I was overly concerned). It only works for loading on a loading dock or ditch where the angle of the ramp is trivial, but with this device I can independently set the ramp up on the tailgate, roll the bike into the carpeted 'chocks', secure the bike with straps from the engine guard to the eye bolts, and then grab the rear fender and push the bike and platform up into the back of the truck and twist the whole thing (easy to slide on my plastic bed liner) to a 45 degree angle for transport (with additional tie downs to the truck itself). Easy as pie! And, when I need to work on it off of the kick stand, I just roll up into it and temporarily tie the bike down as seen. Perfecto! There are MANY of these bike harnesses out there that our group has built, but I just thought I'd share mine too :) |
|
Title: Re: My new S40 work station/hauler/ramp Post by Serowbot on 07/05/15 at 22:46:26 Remember those wooden A B C blocks you had when you were a kid?... Of course you do... that is obvious... The girls learned to spell,.. and we did this... ...and I also learnt... to invent words... Incrediventivtutuitousness... ;D... Nice work, Stew... ;)... |
|
Title: Re: My new S40 work station/hauler/ramp Post by chzeckmate on 07/05/15 at 23:27:48 That's a nice piece of work and a darn clean bike....sparkly :o |
|
Title: Re: My new S40 work station/hauler/ramp Post by Art Webb on 07/06/15 at 10:49:40 Nice! |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |