SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Muffler question /cgi-bin/YaBB.pl?num=1434926187 Message started by Ragnar444 on 06/21/15 at 15:36:27 |
Title: Muffler question Post by Ragnar444 on 06/21/15 at 15:36:27 The inlet to my new muffler has a 2" diameter inlet and the header is just a little over 1 3/4". What is the best way to mate them. Other than a glass of wine and a little Viagra :) |
Title: Re: Muffler question Post by Serowbot on 06/21/15 at 16:24:21 You can buy adapters... E-bay or a local auto store, etc... You'll need 2 clamps... :-?... |
Title: Re: Muffler question Post by justin_o_guy2 on 06/21/15 at 16:42:35 Id know how I wanted them lined up and take them to a muffler shop or two. If you don't have a solid Tclamp, look that up. Hose clamps just aren't enough and the u bolt clamp is just ugly. |
Title: Re: Muffler question Post by justin_o_guy2 on 06/21/15 at 16:43:28 Id know how I wanted them lined up and take them to a muffler shop or two. If you don't have a solid Tclamp, look that up. Hose clamps just aren't enough and the u bolt clamp is just ugly. |
Title: Re: Muffler question Post by chzeckmate on 06/21/15 at 18:24:58 You could use a reducer. A Google search for "Muffler reducer exhaust shim" should turn up some useful results. |
Title: Re: Muffler question Post by KennyG on 06/21/15 at 18:53:01 Rag, You are better off going to an independent muffler shop and having them make an adapter. The adapter needs about a 7 degree bend in it so the muffler lines up with the bracket that it attaches to and doesn't send all of the exhaust to the rear brake drum. There are a lot of posts on muffler adapters in the technical section. Kenny G |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |