SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Broken bolt
/cgi-bin/YaBB.pl?num=1434040447

Message started by swedishbiker on 06/11/15 at 09:34:07

Title: Broken bolt
Post by swedishbiker on 06/11/15 at 09:34:07

Made a oil change and did look in the hole. Saw something. And there was a piece of a broken bolt on bottom.
Is there anything inside engine that have M6 bolt?  The bolt head should be somewhere.
Or has someone drop it from over the cylinder head.
Don't have any idea of how long it has been there.

Title: Re: Broken bolt
Post by Dane Allen on 06/11/15 at 13:18:01

:o :o :o You mean that was in the crank case? Or in the oil drain bin? If it were in the cylinder then the piston would have struck it and put an end to that engine.

Title: Re: Broken bolt
Post by swedishbiker on 06/11/15 at 13:39:34

Bottom of crank case.
It might been there since 1993 :)

Title: Re: Broken bolt
Post by swedishbiker on 06/11/15 at 23:39:01

Normally when a bolt breaks it happens at the head. This is broken outside the tread. This part should been stuck into something. And the head part should fall to bottom of crankcase.  No marks from any abuse. So my guess is it has been there since the engine was built. The cylinder head cover has M6, maybe there is some M6 inside the clutch cover. Transmission? Most bolt are outside crank case, were the oil is.

Title: Re: Broken bolt
Post by justin_o_guy2 on 06/12/15 at 03:00:06

It would be taped to.my toolbox. One day, mite figure it out.

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.