SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> unknown Ryca part
/cgi-bin/YaBB.pl?num=1432084218

Message started by Jeff71 on 05/19/15 at 18:10:18

Title: unknown Ryca part
Post by Jeff71 on 05/19/15 at 18:10:18

Gang, what am I supposed to do with this?
http://i264.photobucket.com/albums/ii173/mode4eng/20150519_2007540_zpsksphwnvp.jpg (http://s264.photobucket.com/user/mode4eng/media/20150519_2007540_zpsksphwnvp.jpg.html)
Jeff

Title: Re: unknown Ryca part
Post by Dave on 05/19/15 at 18:12:00

That comes as stock equipment with the EMGO muffler. They are adapters to fit different size header pipes.

You don't need it with the Savage.

Title: Re: unknown Ryca part
Post by verslagen1 on 05/19/15 at 18:12:04

I could tell ya... but you're not going to like it. ::)

Title: Re: unknown Ryca part
Post by Gary_in_NJ on 05/19/15 at 19:18:43

Don't feel bad Jeff, I too tried to figure that one out. I also had so much hardware when I was done with the build that I had to go through the instructions to determine if I had forgotten something (I didn't).

Title: Re: unknown Ryca part
Post by Jeff71 on 05/19/15 at 20:50:44

Thanks gang. I have a nice little pile of parts left over (decomp lever, side panel brackets, thumb screws and few other nuts and bolts) so I'll probably put a few of them towards other projects. :)
Jeff