SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> CS-1 Rivet nut? /cgi-bin/YaBB.pl?num=1430624809 Message started by swing69 on 05/02/15 at 20:46:49 |
Title: CS-1 Rivet nut? Post by swing69 on 05/02/15 at 20:46:49 What is the size of the 7 rivet nuts for the ryca cs-1. two diff. sizes? or just diff. hardware. |
Title: Re: CS-1 Rivet nut? Post by Jeff71 on 05/02/15 at 21:56:15 All 7 are the same size. The machine screws are #8. 4 are 5/8" long and 3 are 1/2" long. I can give you part numbers too if you need them. Jeff |
Title: Re: CS-1 Rivet nut? Post by Gary_in_NJ on 05/03/15 at 04:07:54 Mike I couldn't get any of those seat screws to engage, so I replaced them all with longer screws. I believe I used 3/4" long screws for both the rear and bottom locations. |
Title: Re: CS-1 Rivet nut? Post by swing69 on 05/03/15 at 05:49:35 I measured the holes through the vertical part of the seat and got .375 (3/8 diameter) - - but there were no nuts or bolts present. The seat bottom holes measured .312 (5/16), but they were pretty much destroyed. they are different size diameters in my pan. :( No biggie though. I'll just make them all 3/8". Gotta love fixing someone elses crap work. Just another in the long line of doing so! |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |