SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Chopper Wiring Questions /cgi-bin/YaBB.pl?num=1430146714 Message started by nickythegreek on 04/27/15 at 07:58:34 |
Title: Chopper Wiring Questions Post by nickythegreek on 04/27/15 at 07:58:34 I have a few questions about the Chopper Diagram thread (http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1173898705) linked in the Tech Forum > TOC thread (http://suzukisavage.com/cgi-bin/YaBB.pl?num=1181745927). Since it is a closed thread, I figured I would ask here. The diagrams show 2 10A fuses. 1 leading to the 3 position headlight switch and 1 leading to the brake light circuit. However the text states that he used a 7A fuse leading to the headlight and a 3A to the tail. Are these fuses required and if so, which are the correct ones to put inline? |
Title: Re: Chopper Wiring Questions Post by verslagen1 on 04/27/15 at 08:12:12 a 60w headlight only uses 5 amps, so a 7 amp fuse is fine. tail light is a 22w stop and 8w plate lights, 3 amp is fine. if your lights are different, then you'll need different fuses. |
Title: Re: Chopper Wiring Questions Post by Gary_in_NJ on 04/27/15 at 09:15:18 Fuses protect the wires, not the device. When choosing the correct size fuse you need to look at the current draw as well as the gauge of the wire. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |