SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> can't remove drive belt on 2012 S40 /cgi-bin/YaBB.pl?num=1426178367 Message started by rijopiatt on 03/12/15 at 09:39:26 |
Title: can't remove drive belt on 2012 S40 Post by rijopiatt on 03/12/15 at 09:39:26 I've removed everything according to the manual and have pushed the wheel forward as far as it will go. But, I can't get enough slack for the belt to come off, including forcing it up on the edge of the driven pulley and rotating the tire. What I'm I overlooking? Rick in Indiana |
Title: Re: can't remove drive belt on 2012 S40 Post by Gary_in_NJ on 03/12/15 at 09:42:40 You can get additional forward movement of the tire if you rotate the tension adjustor into a down position. If that doesn't work (and it should) simply remove the rear tire. |
Title: Re: can't remove drive belt on 2012 S40 Post by Serowbot on 03/12/15 at 09:54:27 Pull out the axle... :-/... |
Title: Re: can't remove drive belt on 2012 S40 Post by rijopiatt on 03/12/15 at 10:42:13 Pulling the axle did it. The Clymer's manual is a bit off in sequence it seems ( and I've never tried this before-newbie :-/) Thanks guys. BTW-is it better to balance the wheel with or without the driven pulley attached? I read somewhere to include the pulley, but seems not right to me. Rick |
Title: Re: can't remove drive belt on 2012 S40 Post by Serowbot on 03/12/15 at 11:04:56 With or without the pulley,.. won't make much difference... Yer' mostly balancing the tire meat... (all that weight out at the outer circumference flying about)... ;)... |
Title: Re: can't remove drive belt on 2012 S40 Post by justin_o_guy2 on 03/12/15 at 11:08:34 The inner circumference pretty much takes care of itself.. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |