SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Clutch wont disengage /cgi-bin/YaBB.pl?num=1412541567 Message started by scubachef on 10/05/14 at 13:39:27 |
Title: Clutch wont disengage Post by scubachef on 10/05/14 at 13:39:27 I am putting my bike back together and have run into an issue. When I went to attach the clutch cable to the lever it would not reach. I could not get the clutch arm to move up. I took the engine cover off and tried to push in the clutch rod in manually but it wont budge. Same clutch cable, bike was running when I took it apart. I have not replaced any clutch parts, etc. everything is the same except the clutch rod wont push in. Any ideas. :-/ thanks |
Title: Re: Clutch wont disengage Post by verslagen1 on 10/05/14 at 13:46:26 How did you try to pull up the lever? unless your name arnold s. don't think you can do it by hand. put a monkey wrench on the pivoting end and push down. and equally hard to push the pin in. |
Title: Re: Clutch wont disengage Post by justin_o_guy2 on 10/05/14 at 16:30:23 Crescent wrench works well.Pay attention to the gizmo the cable hooks into. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |