SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Carburetor problems /cgi-bin/YaBB.pl?num=1408043785 Message started by DiogoCabecinhas on 08/14/14 at 12:16:25 |
Title: Carburetor problems Post by DiogoCabecinhas on 08/14/14 at 12:16:25 Carburetor problems Screw in the air / fuel mixture, I squeeze till the end and not the bike goes down. And when you pull the handle of the air, sometimes it works sometimes not. |
Title: Re: Carburetor problems Post by Michael L on 08/14/14 at 12:49:39 When it comes to problems like this, I really only have one advice.. Unmount your carb and disassemble it. Check that all the bits and pieces are in functioning condition, if not replace them.. Clean it up, and buy a new gasket set. Then before you put it back together, make sure you got the proper sized jets. |
Title: Re: Carburetor problems Post by verslagen1 on 08/14/14 at 15:11:12 406D6B636B47656661676D6A6C6577040 wrote:
Ugh, google translator. :-? Screw in the air/fuel mixture screw until shut and no drop in rpm - idle mixture jet too big... drop down a size. And when you pull the choke?, sometimes it works sometimes not. If the idle mixture jet is too rich, you don't need choke at all. |
Title: Re: Carburetor problems Post by Serowbot on 08/14/14 at 17:27:49 You need a smaller pilot jet... try #50... |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |