SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Pilot Jet Stripped /cgi-bin/YaBB.pl?num=1405806871 Message started by RangerRide on 07/19/14 at 14:54:31 |
Title: Pilot Jet Stripped Post by RangerRide on 07/19/14 at 14:54:31 I just got my carb off to change the jets out. It appears the previous owner attempted to take the pilot jet out previously. The groove has been stripped. I tried one time to get it but don't want to make it worse before checking here. Any suggestions? |
Title: Re: Pilot Jet Stripped Post by Tocsik on 07/19/14 at 15:52:46 I would say you could use a screw extractor; very carefully! The jets are brass so it should bite pretty good. |
Title: Re: Pilot Jet Stripped Post by rapfohl on 07/19/14 at 16:04:46 Just did the same exact thing. Get a really small screw extractor and just tap it down into the hole and back it out. Easy cause of the brass. |
Title: Re: Pilot Jet Stripped Post by rapfohl on 07/19/14 at 18:44:05 7A69786E676064080 wrote:
Edit: I just checked and I used the screw extractor I used was a #1 extractor. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |