SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> 2 questions help please /cgi-bin/YaBB.pl?num=1403746830 Message started by sal on 06/25/14 at 18:40:30 |
Title: 2 questions help please Post by sal on 06/25/14 at 18:40:30 1st question is how do I make my stock exhaust louder. I'm thinking about drilling holes. If this is a possible route where should I drill? Second where is the fuel air screw? Thanks for any assistance. Sal |
Title: Re: 2 questions help please Post by sal on 06/25/14 at 18:42:50 Sorry I didn't specify I have a 2004 savage. |
Title: Re: 2 questions help please Post by verslagen1 on 06/25/14 at 18:49:27 all QUESTIONS about the savage go in rubber side down. |
Title: Re: 2 questions help please Post by S-P on 06/25/14 at 19:05:04 Sal, (and all noobies)... check out the "Tech documents" on the home page. There are TONS of links to threads about stuff, all categorized: carb/fuel, exhaust, etc. etc. Get familiar with the resources on the site, there's a LOT of cool info on it. This link is from that list of links http://suzukisavage.com/cgi-bin/YaBB.pl?num=1221818822/0#0 |
Title: Re: 2 questions help please Post by engineer on 06/25/14 at 19:12:44 Quote:
The air screw is located on the right side of the carb, under a brass plug. The way to access it is to very carefully drill a hole into the brass plug, it is about the thickness of a nickel. Then run a sheet metal screw or something similar into that hole and pry/pull the plug out. You will then see the adjustment screw down in the recess. Quote:
Some have drilled holes and were satisfied with the results. There are good pictures somewhere in the forum. I think, but am not sure, that most drill four or five 3/16 inch holes in the back plate at the back end of the muffler. I don't remember if they put them inside or outside the circle defined by the rivets. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |