SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Getting the timing right
/cgi-bin/YaBB.pl?num=1402338693

Message started by Xandraelle on 06/09/14 at 11:31:33

Title: Getting the timing right
Post by Xandraelle on 06/09/14 at 11:31:33

I have a 2006 Savage that i have to time but I don't really know how. Any help please? Pictures would really be loved. I know how to get the engine at tdc and have it there now but I don't know how to set up the timing. This was an engine rebuild and I made the mistake of no marking it when taking it apart.

Title: Re: Getting the timing right
Post by verslagen1 on 06/09/14 at 11:36:26

Are you timing the crank to the cam?

http://www.hunt101.com/data/500/medium/cam_line_up.JPG

are you following our tech treads?

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1256079122

Title: Re: Getting the timing right
Post by shorty on 06/09/14 at 14:01:02

make sure the marks line up on COMPRESSION STROKE

Title: Re: Getting the timing right
Post by verslagen1 on 06/09/14 at 14:17:53

77656A776B6A6163040 wrote:

make sure the marks line up on COMPRESSION STROKE

Think about it shorty... until you put the cam in... when is the compression stroke? :-?

Title: Re: Getting the timing right
Post by Xandraelle on 06/09/14 at 14:44:55

OMG THANK! When people always said look for timing marks i always look on the gear *facepalm* THANK YOU SO MUCH. I see where it is now. THANK YOU SO MUCH!!