SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Front Foot Pegs Size
/cgi-bin/YaBB.pl?num=1400682921

Message started by Beagle on 05/21/14 at 07:35:21

Title: Front Foot Pegs Size
Post by Beagle on 05/21/14 at 07:35:21

Does anyone know the size of the mounting hole on the front foot pegs? I'm trying to locate some new pegs and I want to make sure they fit.

A friend of mine gave me some of his old Harley chrome pegs but they are a little too small for the bolt to go through it and I can't make the hole larger (I tried using a dremel and it didn't make a dent!)

Title: Re: Front Foot Pegs Size
Post by verslagen1 on 05/21/14 at 08:44:10

It's a little bigger than Hardly Driven which is probably 3/8"
So I'm guessin' it's 10mm give or take a mile.

:-?

But the threads are smaller.

Title: Re: Front Foot Pegs Size
Post by ALfromN.H. FSO on 05/21/14 at 10:12:34

These guys on ebay have some pegs that are already drilled. A little pricey but easy.

AL

http://stores.ebay.com/D-Z-CUSTOM-CYCLE-WORKS/_i.html?_nkw=savage&submit=Search&_sid=52113343

Title: Re: Front Foot Pegs Size
Post by Beagle on 05/21/14 at 10:45:12

303D333367510 wrote:

These guys on ebay have some pegs that are already drilled. A little pricey but easy.

AL

http://stores.ebay.com/D-Z-CUSTOM-CYCLE-WORKS/_i.html?_nkw=savage&submit=Search&_sid=52113343

Yeah, their pegs are pretty expensive but thanks Al!

Title: Re: Front Foot Pegs Size
Post by Beagle on 05/23/14 at 11:31:29

I went to a hardware store and found the right size screw for the pegs and was able to put my friends's Harely's ones on but they are very loose. They also don't have that "hook" on the end of peg. Is that hook really needed?

Title: Re: Front Foot Pegs Size
Post by WD on 05/23/14 at 23:39:03

313A263B22263D3C520 wrote:

Yep, that "hook" is the downward travel limiter. If you shim the sides of the pegs with wave washers (or even plain washers) you can eliminate most if not all of the play. AND keep the pegs almost where they belong. Take the pegs (new and old) to any welding shop. Show them the difference and get a quote to have a tab added to the bottom of your new pegs. Not going to cost very much, I'd do it for a 6 pack...

Title: Re: Front Foot Pegs Size
Post by Beagle on 05/24/14 at 11:52:18

4655110 wrote:

[quote author=313A263B22263D3C520 link=1400682921/0#4 date=1400869889]I went to a hardware store and found the right size screw for the pegs and was able to put my friends's Harely's ones on but they are very loose. They also don't have that "hook" on the end of peg. Is that hook really needed?