SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> permanent move to MUCH higher elevation /cgi-bin/YaBB.pl?num=1400596748 Message started by shorty on 05/20/14 at 07:39:08 |
Title: permanent move to MUCH higher elevation Post by shorty on 05/20/14 at 07:39:08 my good friends, I tossed the white nylon spacer yrs ago (ran better thanks) but that was @ sea level, now with this permanent move to 4500' I think it will be rich. I need to add some small spacer but don't have the original and don't want THAT much of a thickness anyway. any suggestions on what thickness to start with? I know the idle mix needs adj but thanks to you all, that brass cover was removed ;D |
Title: Re: permanent move to MUCH higher elevation Post by Dave on 05/20/14 at 07:45:06 The pilot jet controls mixture up to abut 1/4 thottle. The needle adjustement is the white spacer or washers you use...and that has effect from about 1/8th throttle up to about 3/4 throttle. The main jet has control from about 3/4 throttle on up. You most likely will have to address all the jetting....not just the needle. In place of the white spacer you can use # 4 flat washers from the hardware store. Three washer is a good place to start.....drop down to 2 washers if you have a flat spot and surging just off idle - but only after making adjustments to the main and pilot jets first. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |