SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> clutch shaft leak...back again? /cgi-bin/YaBB.pl?num=1397661851 Message started by shorty on 04/16/14 at 08:24:11 |
Title: clutch shaft leak...back again? Post by shorty on 04/16/14 at 08:24:11 my speedo hit 18,000 miles so I pulled the clutch cover to fix the clutch shaft leak & inspect the chain tensioner.. it (tensioner) was about to fall out so installed versy-thingy & new suzuki "o" ring on the clutch shaft. it's leaking AGAIN.. anybody figure out a better way? I was thinking of widening the groove in shaft to fit a second "o" ring |
Title: Re: clutch shaft leak...back again? Post by Serowbot on 04/16/14 at 09:08:14 That might create more leakage than it stops... I usually add just a tiny smear of RTV at potential leak points... (around wire exits, o-ring shafts, etc...) Just a little,... |
Title: Re: clutch shaft leak...back again? Post by shorty on 04/16/14 at 10:10:00 will try it next chain inspection....thanks |
Title: Re: clutch shaft leak...back again? Post by justin_o_guy2 on 04/17/14 at 06:28:24 Make sure the groove is clean & the shaft is smooove,,&, do as the Rowboat said, grease the O-ring up some. &, Dont just take someones word for it,, LOOK at that O-ring,, is it too skinny? Is it too loose on the shaft? |
Title: Re: clutch shaft leak...back again? Post by shorty on 04/17/14 at 16:44:46 thanks justin |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |