SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Carbo vacuum hose reinstall solution needed.
/cgi-bin/YaBB.pl?num=1394135481

Message started by Joseph on 03/06/14 at 11:51:21

Title: Carbo vacuum hose reinstall solution needed.
Post by Joseph on 03/06/14 at 11:51:21

Newbie here--as well as owning a Savage (2003 LS650) and motorcycle maintenance.

I realize I should have taken a picture before pulling my carburetor for a spring cleanup.

Alas, I can't put it back together again--even with PDF pics in Service guide and user manual.

I have four carbo fuel and vacuum ports but there are SIX are needed with the materials I have in hand.

On the choke-side of the carb, I've figured out fuel and vacuum hook-up carb and peecock; it is the rear two ports I have two vacuum hoses with no where to plug them to.

I thought it had to be the fuel tank but I don't find port inserts there for those vacuum hoses; so I have two vacuum hoses for the two rear carb ports that I can't figure out where to connect.

Hope my explanation is mostly sensible. Anyone sending me a pick of their carbo port with hoses hook-up will be very much appreciated.

Joseph T.

Title: Re: Carbo vacuum hose reinstall solution needed.
Post by verslagen1 on 03/06/14 at 11:55:42

look at reply #2

http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1098869040

Title: Re: Carbo vacuum hose reinstall solution needed.
Post by EJID on 03/06/14 at 11:58:45

Looks like Versy beat me to it...

Vent tube routing (http://suzukisavage.com/cgi-bin/YaBB.pl?num=1311197310)

http://i600.photobucket.com/albums/tt82/serowbot/vents001.jpg

Title: Re: Carbo vacuum hose reinstall solution needed.
Post by old_rider on 03/07/14 at 05:27:25

EJID's pic shows the two vent hoses ....they don't plug into anything, they just are there for venting overflow.

Title: Re: Carbo vacuum hose reinstall solution needed.
Post by Joseph on 03/08/14 at 05:49:19

Thank you for giving me a clue what I need to do; good to be in a mechanical forum like this and get response above a 6th grade reading level.

Much obliged.
Joseph T.