SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Ryca Clutch Mod Problem /cgi-bin/YaBB.pl?num=1393181813 Message started by Jesse on 02/23/14 at 10:56:53

Title: Ryca Clutch Mod Problem Post by Jesse on 02/23/14 at 10:56:53 I did the ryca clutch mod on my bike and seem to have an issue. Bike in neutral go to start it with the thumb lever decomp, and nothing... the tack jumps and the neural light dims a bit but the starter motor never kicks on. This is where it gets weird... If i then go and pull in the clutch the starter motor starts up and the bike will start without hitting the ignition...  The starter disengages and it idles just fine. After i kill the engine if i pull in the clutch it keeps trying to start. The hard part I had with the wiring was there are two solid orange wires from the sidestand relay and it was hard to tell witch goes to the controls and which to the neutral switch. There's also two yellow/green wires on the controls and nothing to tell me which gets the orange and which gets the orange/black wire... Help!!

Title: Re: Ryca Clutch Mod Problem Post by verslagen1 on 02/23/14 at 11:39:52 Are you talking about this mod? http://rycamotors.com/clutch-mod-wiring-small.gif

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.