SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> oil passage check? /cgi-bin/YaBB.pl?num=1391101360 Message started by Jsud04 on 01/30/14 at 09:02:40 |
Title: oil passage check? Post by Jsud04 on 01/30/14 at 09:02:40 What's the best wat to check to see if oil passages, mainly the head cover, is getting oil to the rockers. |
Title: Re: oil passage check? Post by Dave on 01/30/14 at 09:20:28 Start the bike up and run it for a few seconds. Shut it off, the take off the front valve adjustment cover, and look inside and see if everything is coated with oil. |
Title: Re: oil passage check? Post by verslagen1 on 01/30/14 at 12:27:51 If you find an adapter, one of the rocker shafts has a screw in cap that you could hook up to a oil pressure gage. Not likely to show much pressure at idle. http://www.savageriders.com/verslagen/images/Oil%20flow.jpg |
Title: Re: oil passage check? Post by Jsud04 on 01/31/14 at 16:22:01 Perfect. Thansk for the help. Now I have another question, what are the most common causes for not starting. I have lights and it turns over. No fire...its about 40 degrees out...cylinder was wet but the plug seemed dry.?. Decompression was adjusted to spec. I recently added a raptor capable and disconnected the spark plug wire and the ignitor,.?. While doing a head cover, plug job |
Title: Re: oil passage check? Post by verslagen1 on 01/31/14 at 16:49:46 most common... dead bat, or discharged if it don't show more than 10v while pushing the button, it won't start. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |