SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Battery tender/ryca exhaust adapter /cgi-bin/YaBB.pl?num=1385732107 Message started by sesamestreet on 11/29/13 at 05:35:06 |
Title: Battery tender/ryca exhaust adapter Post by sesamestreet on 11/29/13 at 05:35:06 Just a couple of questions. They were sold out of the battery tender jr so I picked up this solar panel battery maintainer instead, is this suitable? http://i.imgur.com/e0o8KT9.jpg secondly, the ryca exhaust adapter I got doesn't fit all the way up to the stop as seen in this photo. The new harley muffler I got fits about half an inch away from the stop, which is actually about 1.5 inches closer than the old harley muffler it's replacing. http://i.imgur.com/3gDgIto.jpg |
Title: Re: Battery tender/ryca exhaust adapter Post by BuckRYCA on 11/29/13 at 08:06:21 To make the Ryca exhaust adapter fit the header pipe must be trimmed where it mates with the adapter. Look at the Ryca build instruction documents on Goggle Docs (http://www.rycamotors.com/ryca_documents.html). See page 16 of http://www.rycamotors.com/instructional/assembly_guides/RycaCS-1AssemblyGuide.pdf. I used a Dremel cut-off wheel. |
Title: Re: Battery tender/ryca exhaust adapter Post by sesamestreet on 11/29/13 at 09:35:05 Great thanks for the help. I was trying to tighten the adapter onto the header pipe but the clamp and bolt just bent without really tightening the adapter to the header. Am I doing something wrong? |
Title: Re: Battery tender/ryca exhaust adapter Post by justin_o_guy2 on 11/29/13 at 09:36:59 I used a 4 &1/2 " cut off,, & I shot Sparks down by the Battery Vent tube,, Do Not DOOOO Thayut,, The Battery makes Hydrogen Gas, the sparks make that gas explode & the battery will squirt acid around inside your motorcycles guts..So Be Careful,, |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |