SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Voltage Regulator relocation /cgi-bin/YaBB.pl?num=1385092893 Message started by twelveport on 11/21/13 at 20:01:33 |
Title: Voltage Regulator relocation Post by twelveport on 11/21/13 at 20:01:33 Working on installing saddlebags. I have the Suzuki OEM support bars mounted & still working on mounting the bags. Not sure yet if I will have to go with a throw-over or not, but if I do I need to relocate the voltage regulator. Any ideas? |
Title: Re: Voltage Regulator relocation Post by thumperclone on 11/21/13 at 22:36:43 I have the oem supports hard mounted the bags to them with 1/4" plywood in the bags and conduit straps nut and bolted w/ washers from the outside, took off the lacing on the straps and folded them back under secured with zip tyes over 13k this way no probs w/o looking think I used 4 straps each bag or you can trim the straps around the VR |
Title: Re: Voltage Regulator relocation Post by danjray on 11/22/13 at 05:24:21 I used the OEM support and have throw-over bags, I didn't relocate the rectifier and I haven't had any problems yet, about 8k miles on it so far. |
Title: Re: Voltage Regulator relocation Post by twelveport on 11/22/13 at 14:30:32 I threw the bag straps over the fender on top of the voltage regulator and it just did not lay down right. I'm sure I could shove the seat down and make it work, but it just doesnt sit right with me. I'm just kind of picky and would like a nice clean fit. Thanks for submitting your idea. :D |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |