SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> no spark! /cgi-bin/YaBB.pl?num=1384902402 Message started by keith pearson on 11/19/13 at 15:06:41 |
Title: no spark! Post by keith pearson on 11/19/13 at 15:06:41 I am building a custom bike with a Savage engine - I think it's an early engine , the serial number is P401-106734. I wired it all up, and had it running . I now have the tank etc all fitted, so I tried it again - but this time, NO spark. It has a new coil and a new ECU. I have an idea what might have gone wrong, perhaps a loose connection - but when wiring up, I wired a lead from the ignitor to the starter solenoid as shown in the diagrams, BUT it only started while the starter motor ran! so I wired that lead to another power source and it ran OK. But I don't like the idea that I have in reality not wired it right, and now it won't go. I intend to re-wire the whole ignition now. I tested the coil, it is OK, so now I will try to test the ignitor. any ideas please? |
Title: Re: no spark! Post by Steve H on 11/19/13 at 15:31:34 If you wired it so there was always power to the ignitor, it probably overheated and died. They are bad about that if powered and the bike isn't running. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |