SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> front pulley /cgi-bin/YaBB.pl?num=1384637307 Message started by greyhead51 on 11/16/13 at 13:28:26 |
Title: front pulley Post by greyhead51 on 11/16/13 at 13:28:26 am having trouble removing the front pulley, is there some sort of trick to it or do i need a puller? |
Title: Re: front pulley Post by Serowbot on 11/16/13 at 14:00:21 You need an impact wrench... I have managed it a couple of times without, but an electric impact wrench will get it off in seconds... |
Title: Re: front pulley Post by v-pilot on 11/16/13 at 15:26:46 It is splined. If you've got the nut and crimp washer off, it should slide off without too much trouble. |
Title: Re: front pulley Post by justin_o_guy2 on 11/17/13 at 08:09:30 If that washer isnt flattened out, its not comin off.. |
Title: Re: front pulley Post by greyhead51 on 11/17/13 at 11:15:43 nuts off so is washer?? |
Title: Re: front pulley Post by verslagen1 on 11/17/13 at 11:35:44 you may have to strike it with a mallet to break it loose. and if that don't work, you may need a puller. |
Title: Re: front pulley Post by justin_o_guy2 on 11/17/13 at 13:45:02 might try puttin it in gear & rockin it back & forth to see if you can get it to shift on the splines any. Have a good look, flashlight time, at the end of the splines on the shaft & pulley & see if there are any burrs hanging up. Or,, go for a ride & see how far ya get before it spits the dang thing into oncoming! Now theres a PLan! NOT!!! |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |