SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Does anyone know?
/cgi-bin/YaBB.pl?num=1383582205

Message started by Ap5112 on 11/04/13 at 08:23:25

Title: Does anyone know?
Post by Ap5112 on 11/04/13 at 08:23:25

Hey everyone does anyone know if there is a way or is it possible to incorporate the bcb bobber kit with a Ryca tank for the savage?

Title: Re: Does anyone know?
Post by Serowbot on 11/04/13 at 09:17:36

Sure,.. why not?... :-?...

Title: Re: Does anyone know?
Post by verslagen1 on 11/04/13 at 09:29:34

gee... that would be like putting harlet parts on a savage. 8-)

Title: Re: Does anyone know?
Post by Ap5112 on 11/04/13 at 09:57:30

Will I run in any trouble where the bcb kit mounts to the tank supports and the peanut tank attaches to the same spot I'm talking the rear mount?

Title: Re: Does anyone know?
Post by sesamestreet on 11/04/13 at 10:17:40

I was thinking of doing just that and I don't see how the bcb kit for the rest would interfere with the tank

Title: Re: Does anyone know?
Post by Ap5112 on 11/04/13 at 10:26:01

I know you have to cut the top motor mount supports and the stock front tank mounts and seeing how there's no speedometer gonna have to buy a mini speedometer and side mount for that and possibly a new speedometer cable and new fuel petcock to fit the new tank

Title: Re: Does anyone know?
Post by Ap5112 on 11/04/13 at 10:43:52

Obviously your not going to use the hing seat support but I'm think that hinge part is going to be in the way might have to grind it off?

Title: Re: Does anyone know?
Post by Ap5112 on 11/04/13 at 14:12:07

Or would it just be easier to use the Ryca hing seat and there seat and not use bcb seat mount and just use the bcb fender bracket to mount the fender?