SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> RYCA CS-1 Oil Check /cgi-bin/YaBB.pl?num=1381179561 Message started by OldSport on 10/07/13 at 13:59:21 |
Title: RYCA CS-1 Oil Check Post by OldSport on 10/07/13 at 13:59:21 This may have been addressed but I can't find it. On a CS-1 build, once you lower the front 2 inches and raise the rear 2 inches how do you properly check the engine oil level? The oil runs to the front of the sump and does not show in the sight glass. I guess I could park on an incline and try to get the engine closer to level? |
Title: Re: RYCA CS-1 Oil Check Post by Gyrobob on 10/07/13 at 14:19:38 I check the oil with the bike upright (not on the stand), with the engine running, on level ground, looking for an 1/8" or so in the bottom of the sight glass. That level verifies there is enough oil inside to show on the glass, but not enough to interfere with the spinny-around stuff. |
Title: Re: RYCA CS-1 Oil Check Post by old_rider on 10/07/13 at 15:05:06 Run the front up on a 4x4, then it will be level. |
Title: Re: RYCA CS-1 Oil Check Post by Dave on 10/07/13 at 16:02:09 I just check it like I did before the conversion.....keep the oil between the marks. Yes....some additional oil is required, and there is a bit more oil up front.....but the oil pump is in the middle and the gear box is near the back....so I just figured I would keep them in the same amount of oil. I have not noticed any negative issues. No additional usage, no additional oil spray coming out the vent hose....no apparent loss of power. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |