SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Anyone successfully jetted a TM36 Mikuni? /cgi-bin/YaBB.pl?num=1374444923 Message started by smokin_blue on 07/21/13 at 15:15:23 |
Title: Anyone successfully jetted a TM36 Mikuni? Post by smokin_blue on 07/21/13 at 15:15:23 After 4 years my project is finally rolling. (I will post project updates shortly) but now I am on to jetting the carb. I have searched the forum to see any info about TM36's might be out there. (Please note this is a different carb than the VM36 that has become a solid part of this forum) What I am looking for is any knowledge base that might exist around the jetting that works for the TM36 on a Savage. Can anyone tell me what jets they used? for reference I am running a stock piston with ported exhaust, high flow header and muffler, cone filter, and midrange cam. Thanks! Smokin_blue |
Title: Re: Anyone successfully jetted a TM36 Mikuni? Post by Gyrobob on 07/22/13 at 03:39:33 What is ported exhaust? |
Title: Re: Anyone successfully jetted a TM36 Mikuni? Post by smokin_blue on 07/22/13 at 04:15:45 Sorry, just means that the exhaust track has been carved and finessed to flow better and open up some of the restriction that is naturally there in the stock head. |
Title: Re: Anyone successfully jetted a TM36 Mikuni? Post by Gyrobob on 07/22/13 at 18:08:01 4C5250545651605D534A5A3F0 wrote:
Who did the porting? |
Title: Re: Anyone successfully jetted a TM36 Mikuni? Post by smokin_blue on 07/22/13 at 19:20:43 A buddy of mine is a drag racer and engine builder and he ports V8 heads as a side job. There is quite a bit on the forum of past porting work done by Lancer and others. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |