SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Mikuni Carb Main Jet Washer! /cgi-bin/YaBB.pl?num=1371838011 Message started by Built2Last on 06/21/13 at 11:06:51 |
Title: Mikuni Carb Main Jet Washer! Post by Built2Last on 06/21/13 at 11:06:51 Burr side up or down? |
Title: Re: Mikuni Carb Main Jet Washer! Post by Dave on 06/21/13 at 12:34:44 I put the smooth side against the carb body (up), and thread the main jet in against the less flat side. |
Title: Re: Mikuni Carb Main Jet Washer! Post by Built2Last on 06/21/13 at 13:09:48 152E2334252932342F272A35460 wrote:
So the burr side up? Mine fell out, and I put it back in burr side up.. but there's a rule to which side goes against the surface, but for whatever reason I can't remember (torched those brain cells).. I believe it's smooth side against the surface to prevent gouging.. |
Title: Re: Mikuni Carb Main Jet Washer! Post by apache snow on 06/21/13 at 13:41:19 The factory manual does not specify which way the washer goes so I assume they think it is unimportant. Either way there is not that much torque applied to the main jet when tightening as to cause a problem. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |