SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> throttle cable adjustment ???
/cgi-bin/YaBB.pl?num=1371425020

Message started by JPSBOBBER on 06/16/13 at 16:23:40

Title: throttle cable adjustment ???
Post by JPSBOBBER on 06/16/13 at 16:23:40

Hi all, my throttle cable has a loos on it, i can turn the handle a bit without the throttle valve opening, is there any way i can adjust it ??h

Title: Re: throttle cable adjustment ???
Post by oldNslow on 06/16/13 at 17:58:40

6E7477666B66666176240 wrote:

Hi all, my throttle cable has a loos on it, i can turn the handle a bit without the throttle valve opening, is there any way i can adjust it ??h

How loose is it? You need a little slack - just enough so the the cable won't open the throttle when you turn the bars all the way to one side or the other.

If You have an owners manual the adjusting instructions are on page 49.

Look at where the cable comes out of the housing on the handelbar. Just past where it bends 90 degrees coming out of the housing is a nut. Loosen it. The long metal piece with the flats on it next to the nut is the adjuster. Turn it out until you can rotate the grip just a bit -maybe an eighth of an inch or so - before it starts to pull the cable. Then run the locknut up against the adjuster and tighten it.

Start the bike and let it idle. Turn the bars all the way from one side to the other and make sure the engine doesn't speed up. If it does loosen the cable a bit. If the idle stays the same you're all set.

Title: Re: throttle cable adjustment ???
Post by oldNslow on 06/16/13 at 18:09:13

7A4445495B4746280 wrote:

[quote author=6E7477666B66666176240 link=1371425020/0#0 date=1371425020]Hi all, my throttle cable has a loos on it, i can turn the handle a bit without the throttle valve opening, is there any way i can adjust it ??h