SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Simple wiring diagram help
/cgi-bin/YaBB.pl?num=1371068792

Message started by stuart on 06/12/13 at 13:26:31

Title: Simple wiring diagram help
Post by stuart on 06/12/13 at 13:26:31

I found the diagrams that were posted on the site and i have attached my diagram that i am using.

I have an 87 savage that i built and re wired using a 4 prong ignition.
The issue: The bike will only stay running if the starter is engaged and spinning the motor, as soon as the key goes to the run position and the starter disengages after it starts the bike shuts right off.

Its getting air, spark and fuel no problems and the carb has been cleaned. I know its probley a simple wiring mistake somewhere.

Any help would be appreciated.

Title: Re: Simple wiring diagram help
Post by stuart on 06/12/13 at 13:27:02

Just a pic of my savage for the hell of it.

Title: Re: Simple wiring diagram help
Post by paulmarshall on 06/12/13 at 13:46:03

Cool looking Savage dude. ;)

Title: Re: Simple wiring diagram help
Post by verslagen1 on 06/12/13 at 13:48:22

I added orange and purple
http://www.savageriders.com/verslagen/Circuits/4wireIG.jpg

Title: Re: Simple wiring diagram help
Post by paulmarshall on 06/12/13 at 13:48:54

Whats the design on the clutch cover?

Title: Re: Simple wiring diagram help
Post by stuart on 06/12/13 at 14:00:53

Thanks alot! Hopefully this will work....im at my end with this wiring.

Just a design I etched onto the cover while I was waiting on my first coat of paint on the tak to dry. Here is another picture of what i started with and where it sits not.

Title: Re: Simple wiring diagram help
Post by stuart on 06/12/13 at 14:01:18

After a wash