SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Ryca tank wiring /cgi-bin/YaBB.pl?num=1369000223 Message started by beacon on 05/19/13 at 14:50:23 |
Title: Ryca tank wiring Post by beacon on 05/19/13 at 14:50:23 I'm starting a Ryca build and wondering how connect the wires to the key switch and LEDS on the tank so you can easily (key word here) get them apart to easily (there's that word again) get the tank on and off the frame. In the instructions the wires appear to be too short. |
Title: Re: Ryca tank wiring Post by Gyrobob on 05/19/13 at 17:39:21 See reply #98 in the Double RYCA Build thread: http://suzukisavage.com/cgi-bin/YaBB.pl?num=1304722902/90 In that thread it will refer you to a description in the Tech section on how to do the ignition-cable-stretching mod. http://suzukisavage.com/cgi-bin/YaBB.pl?num=1312137269 You'll end up with something that looks like this: http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/RYCA%20CS-1%20LS650%20S40%20Savage/DSC03798-1.jpg (http://s258.photobucket.com/user/Gyrobob_theOriginal/media/Motorcycle/RYCA%20CS-1%20LS650%20S40%20Savage/DSC03798-1.jpg.html) |
Title: Re: Ryca tank wiring Post by Holly on 05/19/13 at 19:26:19 The tutorial Gyrobob references is excellent. Since you mention "easy" ... if I had to do it again, I'd extend the ignition wiring from the connector at the rear of the bike forward. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |