SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Eliminating speedometer /cgi-bin/YaBB.pl?num=1368587521 Message started by thomasoconnor19 on 05/14/13 at 20:12:01 |
Title: Eliminating speedometer Post by thomasoconnor19 on 05/14/13 at 20:12:01 I am taking the speedo off of my bike and was wondering if its ok to plug where the cable ends with a rubber vacuum plug? Or do I need something with a better seal that threads on? |
Title: Re: Eliminating speedometer Post by WD on 05/14/13 at 20:46:40 Mine has been open to the elements since a tank swap in 2005, no water has gotten into the engine case, I've opened it up and checked... and very little oil has seeped out. The cable acts as a wick, w/o it the drive unit is fairly well sealed. Your results may vary. My bike is a bit of an odd duck. |
Title: Re: Eliminating speedometer Post by thomasoconnor19 on 05/16/13 at 07:17:49 I am going to just cap it off with a rubber plug. Just was wondering if it may be pressurized and pop it off or something. |
Title: Re: Eliminating speedometer Post by apache snow on 05/16/13 at 08:11:02 Engine has a vent tube to keep that from happening. |
Title: Re: Eliminating speedometer Post by Gheorghe on 05/16/13 at 10:48:47 2B3730323E2C303C303131302D6E665F0 wrote:
Not if your vent is working properly, but I would still put a small zip tie around the cap just to make sure |
Title: Re: Eliminating speedometer Post by verslagen1 on 05/16/13 at 11:22:28 In my junk box I found an old gas fitting that matched the threads on the cap. That and a plastic cap that fit and I got a cap to use when I wash w/out the tank. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |