SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Built-in tool for valve timing inspection plug /cgi-bin/YaBB.pl?num=1368244667 Message started by DavidOfMA on 05/10/13 at 20:57:47 |
Title: Built-in tool for valve timing inspection plug Post by DavidOfMA on 05/10/13 at 20:57:47 Went to check my valve clearances and was stymied by having nothing on hand to remove the valve timing inspection plug - until I discovered that the bracket that holds down the rear of the tank and the front of the seat is a perfect tool for the job. It's almost as if they designed it for that purpose. Just wanted to pass that on. |
Title: Re: Built-in tool for valve timing inspection plug Post by Serowbot on 05/10/13 at 21:37:23 Das' right clever, dat' is!... ;)... ...(I use an old brake pad plate)..., but.. I never thought of the seat doo-dad... :-?... |
Title: Re: Built-in tool for valve timing inspection plug Post by ToesNose on 05/11/13 at 04:13:16 That's a good one, put it in daily hot tip David ;) |
Title: Re: Built-in tool for valve timing inspection plug Post by DavidOfMA on 05/11/13 at 05:45:36 5E656F794465796F0A0 wrote:
Good idea. Done. |
Title: Re: Built-in tool for valve timing inspection plug Post by justin_o_guy2 on 05/11/13 at 10:18:32 I have a coupla fat washers, different diameters, on a rod. The larger one I ground to fit the shape of the slot. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |