SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> put a stock size back on the front: impressions
/cgi-bin/YaBB.pl?num=1367607710

Message started by runwyrlph on 05/03/13 at 12:01:50

Title: put a stock size back on the front: impressions
Post by runwyrlph on 05/03/13 at 12:01:50

The (first) last time I replaced my front tire i accidently ordered a 110-90-19. I got it mounted on the wheel, then found out my fender was too small! I ended up raising the fender about 1.5 " with brackets made of 1/8 steel. I ran it that way for about ?? 12K ?? Didn't really notice much of a difference going to the larger tire at that time.

It was time to replace again, I went back to the 100-90-19 (same model- Kenda Challenger). First ride was this AM-

I was surprised- handling was considerably improved with the stock size tire. I really noticed it when hitting curves fairly hard. It feels a lot more stable. (Not much difference going straight, maybe a little easier to start into turn from going straight)

Maybe my fender bracket allowed a little more flex than just the fender? 3-4 years ago when i switched it maybe i just didn't curve as hard?

(I do think it looked a little better with the bigger tire and higher fender)

Title: Re: put a stock size back on the front: impression
Post by Serowbot on 05/03/13 at 12:11:24

I imagine the taller tire would increase rake, very slightly, and also shift weight to the rear... very slightly again...
I doubt if I would notice...

Maybe you just have a better, fresher tire... (that, I would notice)...

You gotta' love fresh meat on pavement... :-?...

Title: Re: put a stock size back on the front: impression
Post by WD on 05/03/13 at 13:31:05

Next time, try a 2.75 or 3.00-19, in conjunction with a 130 rear... you'll scare yourself with how much faster the bike turns... and the 130/?-15 rear is for a Honda super scooter (Pacific Coast), serious life span on our bikes.

Tried that combo on Max Morley's advice years ago... turns your "Slopoki Salvage" into a decent handling machine... ::)

It is tricky to find a long lasting tire in skinny 19 inch though...

Title: Re: put a stock size back on the front: impression
Post by apache snow on 05/03/13 at 14:50:58

http://www.motorcyclespecs.co.za/model/Honda/honda_pc_pacific_coast_800%2093.htm

Title: Re: put a stock size back on the front: impression
Post by Serowbot on 05/03/13 at 16:21:55

Isn't that bike, nicknamed the Flying Urinal?... ;D...
http://www.motorcyclespecs.co.za/Gallery/Honda%20PC%20800%20%2088%20%202.jpg