SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Rear Turn Signal Replacement /cgi-bin/YaBB.pl?num=1365520627 Message started by conlime on 04/09/13 at 08:17:06 |
Title: Rear Turn Signal Replacement Post by conlime on 04/09/13 at 08:17:06 Broken rear turn signal. I can not for the life of me figure out how to take the whole thing of and replace. Any advice? I will upload pictures tonight. It seems to be screwed into the chrome bracket under the seat that holds up the sissy bar. Thank you. |
Title: Re: Rear Turn Signal Replacement Post by EJID on 04/09/13 at 08:22:22 Look at the attached microfiche...you will see a screw from the bottom that holds it into place. (Screw #15) http://www.ronayers.com/Fiche/TypeID/26/Type/TURN_SIGNAL_LAMP/MakeID/2/Make/Suzuki/YearID/46/Year/2005/ModelID/6193/Model/LS650_S40/GroupID/251220/Group/TURN_SIGNAL_LAMP |
Title: Re: Rear Turn Signal Replacement Post by justin_o_guy2 on 04/09/13 at 08:29:25 THat isnt a #2 philips. If you start with a #2 & grind the tip till the blades fill the X, it will work, but this is where an impact pays for itself. |
Title: Re: Rear Turn Signal Replacement Post by Dave on 04/09/13 at 09:22:51 I also believe you will need to remove the chrome side rail from the fencer. The wire is routed through that and there are 2 plastic clamps that hold onto the wire and don't let it slide out. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |