|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Rear shock swap out /cgi-bin/YaBB.pl?num=1364087944 Message started by 87 savage on 03/23/13 at 18:19:04 |
|
Title: Rear shock swap out Post by 87 savage on 03/23/13 at 18:19:04 After reading B.J.orJo's post about riding 2up entitled "Problably dumb noob question but here it goes?" In that post WD mentioned swapping in a pair of shocks off of a Suzuki Intruder. Does anyone know how much it would actually raise the rear of the bike and in what way does it change the ride. And is it a direct bolt on with no mods? Thanks in advance for any info. |
|
Title: Re: Rear shock swap out Post by Johnny57 on 03/23/13 at 18:38:00 I have neither bike at home here but savage has 10.5 I believe and stock intruder shocks are 12.5. Considering the angle of the dangle and a little Pythagoreum theorum you should be able to compute the height. I would guess about 3.5 inches. Someone who has the bike at home, help me out with the math. |
|
Title: Re: Rear shock swap out Post by ZAR on 03/23/13 at 20:14:24 Actually,the point is not really how much the shocks raise the bike,but rather how low it sinks when the shocks are loaded....weight of rider/s and luggage. The Intruder shocks do raise the static height of the bike,maybe 2-3". The benefit of the swap is that you can ride "two-up" without bottoming the fender on the tire( ;) no cut tires) and enjoy a more cushioned ride. WD will have to expound on the technicals of the swap! |
|
Title: Re: Rear shock swap out Post by Oldfeller on 03/23/13 at 20:24:01 87, remember that you don't have to put on different shocks just to get some road clearance. Over the years I have put on a variety of very large tires on the back end of my Savage and at times I have broken the 300 pound number a couple of times (currently at 288 right now). To get road clearance on an oversized tire all that is needed to be done is put the stock shock in the highest pre-load setting. Stock tires and 300 pounds certainly don't require anything other than a quick and easy pre-load setting change. And I will say you should all check your pre-load setting occasionally as I have had mine shift from high pre-load to a lesser pre-load all by itself. |
|
Title: Re: Rear shock swap out Post by ZAR on 03/23/13 at 20:36:29 1231393B383131382F5D0 wrote:
Right again OF ;) . Memo to self......add to pre-dragon checklist....check rear suspension and shock settings :-[ |
|
Title: Re: Rear shock swap out Post by 87 savage on 03/24/13 at 04:58:42 Thanks for the quick replies! Oldfeller, I don't really want to lift the bike as I'm only 5'8". I read in that post that the Intruder shocks would also improve the ride 1up. |
|
Title: Re: Rear shock swap out Post by WD on 03/24/13 at 10:42:37 I'm 6'2" 240#. The Intruder shock raise the rear roughly 3" when unloaded. Stock shocks...http://i1277.photobucket.com/albums/y490/mphsgal/LISA-HP/Photos/Savage/pokeydone1_zps4f01ca6c.jpg Intruder shocks...http://i1277.photobucket.com/albums/y490/mphsgal/LISA-HP/Photos/Savage/repaint1_zps11d8d11c.jpg The swingarm angle isn't very noticeable in those but, with the stock shocks the fender would grab speed bumps. With the Intruder shocks the fender has a couple extra inches of clearance. Plus it adds some weight over the front end. No action without consequences. I wear 34" inseam jeans and can still flat foot the bike. Even with the VN800A seat it now has, which is a good bit thicker/higher than the stock unit. |
|
Title: Re: Rear shock swap out Post by WD on 03/24/13 at 10:47:53 As far as the install goes, it is a direct swap. Same sized shock eye bushings, same sized bolts. Pop off the stock shocks, lift the bike with a floor jack under the emissions shelf, bolt on the new shocks. Give yourself some time to adjust/adapt to the new feel. It seriously messes with the handling compared to stock. It rides better, but does not respond to steering inputs as quickly. Very HD Dyna Glide-esque... |
|
Title: Re: Rear shock swap out Post by Serowbot on 03/24/13 at 11:25:55 Direct bolt-on swap... If you use the stock belt guard,... you need to trim a little at the front edge because of the added angle of the belt... and replace one engine bolt with a flatter roundhead allen bolt... It does raise the seat height a few inches, but that is reduced to about an inch once you sit on the bike... Gives a very nice ride... ;)... just a few minutes with a file... http://i600.photobucket.com/albums/tt82/serowbot/cgp-001.jpg this bolt... http://i600.photobucket.com/albums/tt82/serowbot/rhas003.jpg http://i600.photobucket.com/albums/tt82/serowbot/rerun/rrshot051.jpg |
|
Title: Re: Rear shock swap out Post by 87 savage on 03/25/13 at 01:42:06 Sweet looking bike Serowbot! Where did you get the tank? |
|
Title: Re: Rear shock swap out Post by Serowbot on 03/26/13 at 16:54:03 262B2522353376707E7F470 wrote:
Sorry 87',... I just came across your question... It's a stock tank, chromed... with rubber knee pads and strip added... ;)... http://i600.photobucket.com/albums/tt82/serowbot/rerun/lemone004.jpg |
|
Title: Re: Rear shock swap out Post by engineer on 03/26/13 at 18:47:18 Thinking about Oldfeller's comment. I set my shocks on the least pre-load a couple years ago based on a short first test drive up and down my street. A lot of what I consider a rough ride on my S40 is caused by the occasional hammer blow to the spine when they bottom out on a rough spot in the pavement and also the bouncing that goes on which keeps flexing my back. I kept mine set soft thinking I was helping with the ride (always ride single and 165 lbs) but I'm going to set the pre-load up on those babies and see how that works out on the next long ride. Anyway I have a set of 11-1/2 inch Sportster shocks I haven't installed yet. They are slightly softer and will give me another inch of travel and I think they short enough that I will not even need to trim the belt guard. |
|
Title: Re: Rear shock swap out Post by 87 savage on 03/27/13 at 01:50:42 616368636A636F75060 wrote:
Engineer, I'm going to follow your lead and Oldfellers Idea and set the pre-load up on my shocks and see how it rides. I know exactly what your saying. I'm riding along enjoying the sun, minding my own business and then BAM I hit a bump that looks like nothing but is almost bone jarring! It feels as if there is no suspension sometimes. |
|
Title: Re: Rear shock swap out Post by Gibsonman on 06/29/13 at 16:39:15 Have any of you had any success in getting rid of the bottoming out issue? Thanks, Des |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |