SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> puller /cgi-bin/YaBB.pl?num=1359514246 Message started by alg on 01/29/13 at 18:50:45 |
Title: puller Post by alg on 01/29/13 at 18:50:45 im trying to get to my sprag clutch and to do so i need to pull the rotor. i dont necessarily want to buy the tool for a one time job. any suggestions? |
Title: Re: puller Post by Cavi Mike on 01/29/13 at 19:55:47 I can't remember which but Auto Zone or Advanced Auto loans tools out for free, you just have to give them a 100% deposit. Fully refunded when the tool is returned. |
Title: Re: puller Post by Demin on 01/30/13 at 04:50:17 It's a special tool.I think it's 50mm threads on it.I had to buy one for the build I'm doing now.I think it was around 60-70 bucks.I have to figure out a timing issue on m ine. |
Title: Re: puller Post by Dave on 01/30/13 at 05:32:40 I had to buy one - your only other choice would be to take the bike to the dealer and ask them to pull it for you. |
Title: Re: puller Post by ZAR on 01/30/13 at 19:23:37 7C474A5D4C405B5D464E435C2F0 wrote:
And I'm guessing the "stealership" would have charged $100+ for the job? |
Title: Re: puller Post by Dave on 01/31/13 at 05:00:17 03180B590 wrote:
And I'm guessing the "stealership" would have charged $100+ for the job? [/quote] I was tempted to go to the dealer - but then I thought about the time it took to take the engine to them, the thought of leaving the engine there, going back to pick it up, etc. I just decided to buy one. I would be willing to rent it to responsible people......I would have to charge a depost fee. I also made a tool to hold the flywheel while tightening that nut, and the large deep socket for the flywheel nut. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |