SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Verslavy Installed....how many more miles
/cgi-bin/YaBB.pl?num=1353690292

Message started by gdrseeker on 11/23/12 at 09:04:51

Title: Verslavy Installed....how many more miles
Post by gdrseeker on 11/23/12 at 09:04:51

I installed my Verslavy and the bike is much quieter.....no more ticking time bomb. I had 23K miles on my bike and the adjuster was about 22mm out. THANKS Verslagen1.

How many more miles do you think I will get before I need to replace the chain?

Title: Re: Verslavy Installed....how many more miles
Post by Coaxial on 11/23/12 at 09:06:53

Will be in the same predicament as you and would like to know =)

Title: Re: Verslavy Installed....how many more miles
Post by wambr on 11/23/12 at 09:27:26

I think that if after 23k miles of your chain tensioner began to have an output of the rod, 22mm, then certainly mileage nga savage until very critical point would be about 4-5K miles... not anymore. it's just in their observations.

Title: Re: Verslavy Installed....how many more miles
Post by verslagen1 on 11/23/12 at 10:22:29

You can expect to double the mileage, and maybe more.
I've changed mine out at 50k miles.

Title: Re: Verslavy Installed....how many more miles
Post by Coaxial on 11/23/12 at 10:31:40

i heart you verslagen. I hope you had a good thanksgiving!

Title: Re: Verslavy Installed....how many more miles
Post by wambr on 11/23/12 at 22:03:45

i told about quality of camchain. i buy bad quality and now i have to change again.
sorry for my english. i'm not wake up :)

Title: Re: Verslavy Installed....how many more miles
Post by 360k+ on 11/24/12 at 07:55:02

5E5D4B4A5C5C525C4B390 wrote:

How many more miles do you think I will get before I need to replace the chain?

The answer, my friend, is blowing in the wind...

Title: Re: Verslavy Installed....how many more miles
Post by gdrseeker on 11/24/12 at 08:11:14

I like verslagen's answer I will keep an eye on it though. 50k here I come.

Next up .....fork seals.