SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Post 95 wiring harness on an 87 bike. /cgi-bin/YaBB.pl?num=1351619870 Message started by srinath on 10/30/12 at 10:57:50 |
Title: Post 95 wiring harness on an 87 bike. Post by srinath on 10/30/12 at 10:57:50 I am thinking of running an 96 wiring harness on this 87 I got. Cos I cannot find the rear cover of the start switch unit. And that switch wont come off the wiring ... Therefore I want to swap the wiring to one where I got the switch assy that can be unplugged. So what would work/not work and what needs to be modded if I want to use an 96 and later harness on my 87. Thanks. Srinath. |
Title: Re: Post 95 wiring harness on an 87 bike. Post by verslagen1 on 10/30/12 at 11:26:04 Front brake switch and cdi is all that I can recall. brake switch goes from a wiper and plate contacts to a modular switch. cdi connector is different, don't swap cdi's unless you swap the rotor too. I have an '88 wiring and control set if you want to swap, but i'd want to swap the whole set. not just one control. |
Title: Re: Post 95 wiring harness on an 87 bike. Post by srinath on 10/30/12 at 11:33:32 3E2D3A3B24292F2D2679480 wrote:
OK I have the 87 CDI and the wiring as well, just that start switch back cover is not there. Front brake not an issue, I have 96+ brakes to put in if needed. The pins of the cdi on 96 to the wiring are different in location but the outer housing for the pins are the same ? So I can pull the terminals out of the molex connector and swap em with the color codes of the 87 as reference ? Cool. Srinath. |
Title: Re: Post 95 wiring harness on an 87 bike. Post by verslagen1 on 10/30/12 at 11:40:38 Different number of pins, different connector. See the tech section for a pin out chart. You might be able to pull the pins out of one and shove it in the other. |
Title: Re: Post 95 wiring harness on an 87 bike. Post by srinath on 10/30/12 at 13:45:18 4A594E4F505D5B59520D3C0 wrote:
I cant find it in the tech section, But I will get it and work on it and post back. Thanks vers. Cool. Srinath. |
Title: Re: Post 95 wiring harness on an 87 bike. Post by verslagen1 on 10/30/12 at 14:47:41 cdi connector http://suzukisavage.com/cgi-bin/YaBB.pl?num=1293638302 |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |