SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Rubber thingie removers
/cgi-bin/YaBB.pl?num=1348870451

Message started by Greg on 09/28/12 at 15:14:08

Title: Rubber thingie removers
Post by Greg on 09/28/12 at 15:14:08

I purchased a pair of billet aluminum adapters from Scootworks to remove the black robber spacer from my rear turn signals. I only have 1 mounted as my left replacement isn't scheduled for delivery until Monday. I think it looks sweet!

Title: Re: Rubber thingie removers
Post by Cavi Mike on 09/28/12 at 15:54:34

I was debating doing that or just get whole new signals. Looks good.

Title: Re: Rubber thingie removers
Post by Greg on 09/28/12 at 15:58:51

Thanks. I do like the look of Suzuki's signals. Just not the look of the rubber thing. They also have an adapter to move them to the license plate.

Title: Re: Rubber thingie removers
Post by Charon on 09/29/12 at 05:01:37

You will probably want to make sure there is some "give" in the turn signal stalk. The rubber spacer helps isolate some of the vibration of the bike from the turn signal bulbs, so the filaments last longer.