SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Size of Front Forks?
/cgi-bin/YaBB.pl?num=1347158333

Message started by jgrandmont on 09/08/12 at 19:38:53

Title: Size of Front Forks?
Post by jgrandmont on 09/08/12 at 19:38:53

I'm looking to install a set of Photon Blasters on my front forks and will need some clamps for them. Does anybody know the dimension of the lower (outer) fork tube?

Title: Re: Size of Front Forks?
Post by verslagen1 on 09/08/12 at 20:03:31

Title: Re: Size of Front Forks?
Post by jgrandmont on 09/08/12 at 20:31:11

And that's at the lower end (larger diameter) of the forks where the front wheel attaches, not the upper end (smaller diameter) where the turn signals attach, correct?

Title: Re: Size of Front Forks?
Post by rfw2003 on 09/08/12 at 20:43:59

Nope that is the smaller part. If it's not posted by tomorrow I will go out and take a measurement to get that for ya

Title: Re: Size of Front Forks?
Post by LouSiana on 09/09/12 at 02:30:00

I have just been outside and measured it out.
It is about 50mm. At the lowest point I measured 50,3mm and higher, just below where it gets thicker (slide and gasket part) it was about 49,5.

So a 50mm clamp will do it.

Title: Re: Size of Front Forks?
Post by jgrandmont on 09/09/12 at 06:08:29

Thanks, guys!