SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Front Fender
/cgi-bin/YaBB.pl?num=1346732757

Message started by Mr.Orange on 09/03/12 at 21:25:57

Title: Front Fender
Post by Mr.Orange on 09/03/12 at 21:25:57

Anyone know of a way to move the location? Like lower to the ground toward the engine?

Title: Re: Front Fender
Post by justin_o_guy2 on 09/03/12 at 22:37:20

Study & measure how far youd want to rotate it back. Remove it, cut off the front far enough ahead of where you want the edge to have enough out there to be able to finish it out. Take the part ya hacked off & weld it to the back side, cut off where ya want it. Season to taste.

Title: Re: Front Fender
Post by Cavi Mike on 09/04/12 at 07:17:44

Can you weld? Do you have an angle-grinder with a cut-off wheel? Have you ever used a screw-driver before?

Title: Re: Front Fender
Post by Mr.Orange on 09/04/12 at 15:15:35

no to weld. yes to cut off wheel.

Title: Re: Front Fender
Post by justin_o_guy2 on 09/04/12 at 16:28:32

You get it all figured out & cut like ya need it. Ill bet you can find a welder with a TIG who will stick it back together for ya. The guy who did my exhaust didnt even charge me, but then, I made sure to put every tool we used exactly where we got it from.

Even if ya dropped $40.00 on it, would that bother you?

You know youd have to grind it carefully & prime it & sand it several times to get it ready for paint, or grind it & put a thin layer of bondo on it,

Title: Re: Front Fender
Post by Mr.Orange on 09/04/12 at 17:59:41

k thanks will see what i can do