SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Put in the Verslavy but Now... /cgi-bin/YaBB.pl?num=1343168629 Message started by nooner on 07/24/12 at 15:23:49 |
Title: Put in the Verslavy but Now... Post by nooner on 07/24/12 at 15:23:49 the bike starts and revs but shuts off as soon as I try to put it in gear. What do I do now? Thanks. |
Title: Re: Put in the Verslavy but Now... Post by verslagen1 on 07/24/12 at 15:25:56 kick stand up? |
Title: Re: Put in the Verslavy but Now... Post by nooner on 07/24/12 at 15:33:51 Thanks verslagen1. That was it. I think will take my dunce cap off after about 10 minutes. Hopefully, that will be long enough. :-[ |
Title: Re: Put in the Verslavy but Now... Post by Savage_Rob on 07/24/12 at 15:56:44 I love the ones that are easy to fix. |
Title: Re: Put in the Verslavy but Now... Post by arteacher on 07/24/12 at 16:06:47 Last year my grandkids were climbing on it and it wouldn't start the next day. I had pulled the seat off and was getting ready to pull the tank to look for the wire that had obviously been pulled loose when I noticed......... the kill switch had been tripped. :-[ |
Title: Re: Put in the Verslavy but Now... Post by 87 savage on 07/24/12 at 17:37:50 Thats a good one nooner ;D But don't feel bad. A few years back after spending a couple days rebuilding the engine in a ski-doo mxz, the big moment came. Gas...check, plugs correctly gapped...check, 2 stroke oil...check, key on...check. Pulled and pulled and pulled wouldn't even sputter. After several frustrating hours trying everything to start it I started to disassemble it again when I noticed I had not replugged in the connector on the wiring harness to the coil! Doh! ::) |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |