SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> ryca wiring question /cgi-bin/YaBB.pl?num=1338776397 Message started by bikertrash on 06/03/12 at 19:19:57 |
Title: ryca wiring question Post by bikertrash on 06/03/12 at 19:19:57 Can any of you that have done the ryca conversion tell me how you dealt with the wiring from the tail light to the battery box? Because I was anxious to ride mine, I took some duct tape and secured it up under the fiberglass tail section. Functional, yes, but not how I want to leave it. Ideas? |
Title: Re: ryca wiring question Post by scubachef on 06/03/12 at 22:03:20 Don't have a ryca but for my taillight wiring I welded a small bolt to the bottom of the metal tail I made and used insulated wire clamps held with washers and nuts to hold the wires. You could do the same by fiber-glassing a bolt or something to the bottom of your tail and pan. I used two clamps to span about 14 inches. |
Title: Re: ryca wiring question Post by bikertrash on 06/04/12 at 06:44:20 Good idea--thanks! :) |
Title: Re: ryca wiring question Post by irondad01 on 06/04/12 at 16:44:12 On the trike I built, under the rear fenders I ran some of the split plastic wire loom you can get at NAPA. I taped it in place then fiberglassed over it. I ended up with a fiberglass tunnel to run my wires through. You could use light plastic tube etc. For a larger one I used a piece of garden hose that I waxed with car paste wax then pulled out after the fiberglass hardened. Carl |
Title: Re: ryca wiring question Post by bikertrash on 06/04/12 at 19:53:31 No shortage of good idears! Thanks guys! |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |