SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Dyna Muffler adapter question /cgi-bin/YaBB.pl?num=1338400601 Message started by Jacob on 05/30/12 at 10:56:41 |
Title: Dyna Muffler adapter question Post by Jacob on 05/30/12 at 10:56:41 I am installing a HD Dyna FXD this weekend on my 2012 S40. I'm pretty sure I'll need a adapter. Anyone know what size between the header and muffler I'll need? Thanks |
Title: Re: Dyna Muffler adapter question Post by Greg on 05/30/12 at 11:17:30 Dyna side is 1.75"OD. LS650 side is bigger than 1.625ID. I know this because that is what I purchased. Eyeing up the adapter, I would say 1 11/16"ID but I couldn't find one. I purchased some exhaust tape from Autozone and put 2 layers on the head pipe. So far so good. Make sure you cut slits in the Dyna muffler. http://www.autozone.com/autozone/accessories/VersaChem-72-sq-in-Tiger-Patch-muffler-tailpipe-repair-tape/_/N-25hw?itemIdentifier=827123_0_0_ |
Title: Re: Dyna Muffler adapter question Post by Jacob on 05/30/12 at 12:30:29 What exact adapter will I need with the muffler tape? It will need to be the correct O.D. and I.D. |
Title: Re: Dyna Muffler adapter question Post by Greg on 05/30/12 at 13:09:08 I didn't use an adapter with the muffler tape. The ID of the Dyna muffler is 1 3/4" (1 6/8" for the fractionally-challenged ;D ). The OD of the Savage pipe is a little bigger than 1 5/8". I just wrapped 2 layers of tape, slid on the muffler and clamped it down. |
Title: Re: Dyna Muffler adapter question Post by Serowbot on 05/30/12 at 13:11:40 5257505B5C56350 wrote:
Greg... you made that way too easy... ;D... That's cheating,... :-?... |
Title: Re: Dyna Muffler adapter question Post by Greg on 05/30/12 at 16:30:06 6E786F726A7F72691D0 wrote:
Greg... you made that way too easy... ;D... That's cheating,... :-?...[/quote] Now that I rode it hard for a while I developed a slight leak. I am just gonna smoosh muffler mud on the seam. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |