SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> raptor petcock /cgi-bin/YaBB.pl?num=1335325113 Message started by chad levert on 04/24/12 at 20:38:33 |
Title: raptor petcock Post by chad levert on 04/24/12 at 20:38:33 im going to go ahead and order the raptor 660 petcock for my savage. one question, whats the best way to plug the vac line fitting on the carb? |
Title: Re: raptor petcock Post by verslagen1 on 04/24/12 at 21:11:25 your favorite dead cat makes a wonderful plug. ::) |
Title: Re: raptor petcock Post by Dj12midnit on 04/24/12 at 21:21:08 cat is to big wont fit. |
Title: Re: raptor petcock Post by chad levert on 04/24/12 at 21:22:51 my fav dead cat huh? that must be some slang i dont know about lol, but for real whats the best way? i was thinking i would tig weld it closed with a copper-zinc rod, but theres got to be a easier, trustable way... |
Title: Re: raptor petcock Post by Arizuno on 04/24/12 at 21:29:43 Autozone has caps to plug your carb. Just tell 'em what you're doing & they'll fix you up. |
Title: Re: raptor petcock Post by thumperclone on 04/24/12 at 21:30:10 golf tee those lil plastic caps they use on wire shelves |
Title: Re: raptor petcock Post by Serowbot on 04/24/12 at 23:26:01 Serious... I found a tapered screw, ... that tapped in snug, without boogering the the outer of the brass nipple... Perfect... completely reversible, and fully secure... then I covered the screw with a rubber nipple for cosmetic dressing... I tried several rubber covers, and they all seem to rot away after a period of months... so, close it good... ;)... |
Title: Re: raptor petcock Post by verslagen1 on 04/24/12 at 23:30:34 you might look in a hardware store for a copper tubing cap. fill it up with rtv and shove it on. |
Title: Re: raptor petcock Post by aintright on 04/25/12 at 20:20:00 2C22797A25212C26213C480 wrote:
not if you shove it hard enough |
Title: Re: raptor petcock Post by aintright on 04/25/12 at 20:21:20 i just did this last night and for the time being a went a lil ghetto fabulous and cut most of the stock tube, rolled it up and put two zip ties on it. i'll be getting a rubber plug once i get to the store again |
Title: Re: raptor petcock Post by Digger on 07/21/12 at 20:13:29 70787F656378767965110 wrote:
Yep....sometimes ghetto be good... Here's what I'm rocking on my bike: http://i235.photobucket.com/albums/ee201/Digger109/CarbVacuumPortPlugE.jpg I squirted some RTV into the tube before folding it. The tube was the OEM vacuum tube. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |