|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Clutch push rod won't move /cgi-bin/YaBB.pl?num=1334152718 Message started by wombat on 04/11/12 at 06:58:37 |
|
Title: Clutch push rod won't move Post by wombat on 04/11/12 at 06:58:37 I took the crankcase covers off to powdercoat them. Before reassembly I tried to push in the little pin (clutch push rod) that activates the clutch, but it wouldn't budge. So, I figured that once the cover was on the cover's clutch lever would have a better chance of doing it rather than my soft little finger. But, noooo. The lever hits the rod and nothing happens. Any idea of what might be wrong? |
|
Title: Re: Clutch push rod won't move Post by justin_o_guy2 on 04/11/12 at 07:01:48 Can ya pull it out? |
|
Title: Re: Clutch push rod won't move Post by verslagen1 on 04/11/12 at 08:23:06 How long did you have it dry? Might be just stuck. And yeah, it'll take a lot of force to push it in by hand. imagine the leverage you get from the clutch lever on the outside of the case vs. inside. and the outside you still need some help. |
|
Title: Re: Clutch push rod won't move Post by justin_o_guy2 on 04/11/12 at 08:55:57 If I have the cable off the lever on the case, I have to put a crescent wrench on the arm to move it up, which is how I disconnect the clutch cable, so I dont have to mess with all those adjustments. |
|
Title: Re: Clutch push rod won't move Post by wombat on 04/11/12 at 12:19:26 The pin slips in and out of its hole quite easily. 6A757374696E5F6F5F67757932000 wrote:
|
|
Title: Re: Clutch push rod won't move Post by wombat on 04/11/12 at 14:27:16 Yup! A wrench had enough leverage to make it moves. Feels okay now. Thanks! 36292F2835320333033B29256E5C0 wrote:
|
|
Title: Re: Clutch push rod won't move Post by justin_o_guy2 on 04/11/12 at 23:09:09 Well Awwrite,, |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |